ADAS Safety Calibration in Riverside, CA
Cameras and radar calibrated to factory targets after glass or body work.
ADAS safety calibration resets the cameras and radar that run a commercial van's lane keeping, emergency braking, and distance cruise after a windshield swap, alignment, or body repair. Out-of-aim sensors read the road wrong, which matters most on a loaded fleet van. We calibrate to factory targets in-shop in Yorba Linda, a short run down the 91 from Riverside.
What this service includes
- Factory scan of driver assistance modules
- Front camera static calibration to factory targets
- Radar and distance sensor aiming
- Calibration after windshield replacement or alignment
- Verification of lane keeping and emergency braking function
- Fault code clearing after calibration
- Road test to confirm system operation
Who this is for
- Commercial vans after a windshield replacement
- Vans that had an alignment or front body repair
- Drivers with driver assistance warning lights
- Fleet vans relying on lane keeping and emergency braking
Frequently asked questions
When does a commercial van need ADAS calibration?
After a windshield replacement, an alignment, front-end body repair, or a camera or radar replacement. These events change sensor aim, so lane keeping and emergency braking need recalibrating to work correctly.
Why does calibration matter on a loaded fleet van?
Driver assistance systems judge distance and lane position, which is critical with the extra weight and stopping distance of a loaded van. Sensors that read the road wrong can brake late or steer incorrectly, so accurate calibration is a safety item.
Do you calibrate to factory targets?
Yes. We use factory targets and procedures for the static calibration and verify the systems function afterward. We clear any related codes and road test the van.
Get your Sprinter or commercial van back on the road
Serving Riverside from our Yorba Linda facility. Straightforward written quotes, insurance help for collision, and honest, documented work.