# Exterior and Body Mods in Riverside, CA

Canonical: https://commercialvanrepairshop.com/services/body-collision/exterior-body-mods/
Business: Commercial Van Repair Shop, Yorba Linda, CA. Serving Riverside, California.
Phone: (714) 646-1433 | Email: info@ocrvcenter.com

We fit and finish exterior parts on commercial vans in our Yorba Linda shop: fender flares, steel bumpers and grille guards, running boards, rock cladding, and trim. We mount hardware to solid factory points, seal every drilled penetration, and finish exposed metal so road grime and moisture cannot creep in behind new parts. Riverside fleets add steps, guards, and molding without opening the door to rust.


## What this includes
- Fender flare and body cladding fitment
- Steel and aluminum bumper and guard mounting
- Running board and rock rail install
- Drilled-point sealing and corrosion protection
- Flare and trim color match or texture finish
- Body-side molding and rub-strip fitting
- Fastener torque and rattle check

## Who it is for
- Fleets adding steps, guards, or boards to their vans
- Work vans wanting protection for job-site duty
- Vans needing sealed penetrations against road grime
- Commercial vans branded with molding and trim

## Pricing
Ballpark by parts and fitment work, put in writing after inspection. Body labor runs $210/hr.

## FAQ
### Will drilling for accessories cause rust later?
Not if the holes are treated. We prime and seal every drilled point and add corrosion protection, so road salt and grime do not start rust behind flares, bumpers, or boards.

### Can you paint or texture parts to match?
Yes. We color-match flares and trim to the body or apply a textured finish, depending on the look, and blend so the parts do not stand out.

### Do you install parts we supply?
We do, as long as they fit the chassis and mount to sound points. We inspect the parts first and tell you in writing if anything will not mount safely.

### Will the additions hold up to job-site use?
When mounted to factory strong points and torqued right, yes. We check fasteners and seals so nothing rattles loose on rough Inland Empire job sites and back roads.